How to use Omnisense with the Field Transport Case
(Temporary Solution for InterFit)
1. Testing site preparation
a. Make sure there is a table large and stable enough to support the Omnisense 7000S in the Field-use case.
b. Set the case close to its final position (use two people to lift it onto the table by using the dedicated latches)
c. Set up two chairs: 
i. Operator chair facing the unit
ii. Patient chair at the front end of the table, facing the operator
2. Open the case
a. Make sure the unit is in its final, safe position prior to opening it
b. Open the top by undoing the 6 latches (two on each side)
c. If the unit does not open, release the air by opening the pressure release valve on the front (this case is air and water tight!)
3. Start setting up Omnisense for testing
a. Follow these steps for a smooth set-up
b. Remove the keyboard and set it up in front of the case
c. Remove the mouse and set on the mouse pad next to the keyboard
d. Remove the foam over the monitor (held by velcro)
4. Set-up of monitor
a. Carefully remove the monitor from its position in the case top
b. Turn it towards you and tilt the stand up (NOTE: Do not touch or squeeze the blank screen, avoid pulling on the cables).
c. Place the foam back in the original position for later use
5. Final check
a. Check all connections in the back of the computer for a secure, tight fit
b. If you use an external printer : connect the printer cable to the parallel printer port.
c. Locate the power cable and plug it in to main power (110V).
d. Power up the unit by pushing the on-button in the front of the unit.
e. Start testing
6. Packing up Omnisense
a. Clean probes with alcohol tissues and put in dedicated place holders
b. Follow the set up steps in reverse order – starting with the monitor
c. Prior to closing the case, make sure that all cables are inside of the case and do not overlap the case top CABLES WILL BE PERMANENTLY DAMAGED IF SQUEEZED BETWEEN CASE TOP AND BOTTOM!
d. Make sure all accessories are packed in the appropriate location. DO NOT PACK ANY ADDITIONAL PARTS OR ACCESSORIES
e. Carefully and gently close the case top, check one more time that nothing is being squeezed
f. Secure all 6 latches
